Roofing torch tools

Clay Roof Tiles. Slate Roof Tiles. Metal Roof Tiles. Tile Vents. General Appliance Extraction Vents. Roof Shingles. Pipe Flashings. Roofing Felt. Roof Kit Calculators. Green Roofs. Roof Edge Trims. Pitched Roof Windows. Other Pitched Roof Windows. Glazing Systems. Flat Roof Windows. Other Flat Roof Windows. Roof Lanterns. Roof Domes. Bitumen Roof Sheets. Metal Roof Sheets. Pipe Flashing. Polycarbonate Roof Sheets.

Complete the Hands-On Evaluation Complete your hands-on evaluation by recording it on video via cell phone or other camera device and email it to your trainer Recordings can be sent to Certa. Eval mrca. Other Specifications.

Customers also viewed. Sign in here. Recommended Posts. Jeremy Blohm Posted April 5, Posted April 5, edited. Threaded on one end. I will get pictures of everything and post in a day or two!!! Edited April 6, by Jeremy Blohm. Link to post Share on other sites. Jeremy Blohm Posted April 9, Posted April 9, Alan Longmire 3, Posted April 9, I also don't care for the new forum software, makes it much harder to do stuff with a phone. I am interested in seeing how you solved the backpressure issue those burners have.

Jeremy Blohm Posted April 10, Posted April 10, Alan Longmire 3, Posted April 10, Brian Madigan 17 Posted May 5, There are different fittings for vapor and liquid withdrawal systems.

Propane and butane are common fuel sources for roofing torches. The tank must always be kept in an upright position. Protective collar: A tough metal collar is installed on the top of an LP tank to protect it from damage.

It reduces the chance that the valve or regulator is broken off, which could cause a leak or an explosion. Cylinder stand: A cylinder should be equipped with a stand so that you can safely and easily maneuver it. The stand should have a belt to keep the tank upright and a spot to hang the torch. Sometimes roofers will use back-mounted stands.

Foot ring: A circular metal ring is attached to the bottom of the tank to keep it from direct contact with the ground. When lifting a pound tank, one roofer must hold by the foot ring, while the other must hold from the protective collar.

Tank valve: This valve controls the flow of gas from the tank. Never lift the tank by its valve. It also acts a barrier between the torch and the high pressure of the tank. Without the regulator or with an improperly functioning regulator the gas tank and torch are serious safety hazards.

Release valve: LP cylinders have release valves that will allow a small amount of fuel to escape if too much pressure has built up in the tank, preventing the cylinder from breaking open.

Generally, this process takes a few seconds. The valve reseals afterward until the pressure builds again. Propane Regulators for Roofing Applications The regulator is perhaps the most essential part of the roofing torch system. Characteristics of Propane Propane is the most common LP fuel used for roofing applications because it can achieve the necessary temperature, is relatively cheap and is readily available.

However, there are some best practices, such as: It is best to disconnect the torch after use. When the torch is not attached, you should put a plastic plug on the outlet valve of your regulator. Do not attempt to take the regulator or tank valve off! You should not store the tank near heat sources, like furnaces and heat vents.

You should keep the regulator vent clear of any debris. Roofing Gas Torch and Regulator Repair Over time, you may find that any part of your gas torch has become damaged or is no longer working properly. Signs your roofing torch has stopped functioning properly include: You feel a loss of pressure. You feel a loss of heat or the flame goes out. The flame stutters.